
Brookeld Engineering Labs., Inc. Page 34 Manual No. M03-165-F0612
TIMED STOP
SET SEC’S: 00 ↑↓
Figure IV-17
Using the UP and DOWN ARROW keys, the user enters a value for the seconds portion of the time
ramp.Thisvaluewillbefromzero(0)uptofty-nine(59)seconds.Press
ENTER to accept the
value.
Note: The value for either minutes or seconds must be other than zero
or you cannot advance to the RPM input screen (Figure IV-18).
Pressing the OPTIONS/TAB or ENTER/AUTORANGE keys
will cause the user to alternate between the minutes input screen
(Figure IV-16) and the seconds input screen (Figure IV-17) until
either minutes or seconds are anything but zero.
A press of the ENTER/AUTORANGE key allows the user to input the RPM selection. At this point,
the user will see a screen similar to Figure IV-18; using the UP and DOWN ARROW keys, the
user sets the speed.
TIMED STOP
SELECT RPM:30↑↓
Figure IV-18
After selecting the speed, the user may review the values selected. If the user presses the
OPTIONS/TAB key, you will return to the minutes input screen of Figure IV-16 where you may
change the minute input if so desired. Thereafter, continued pressing of the OPTIONS/TAB key will
toggle between the minutes and seconds input screens and the motor input screen. A press of
the MOTOR ON/OFF/ESCAPE key will cancel the timed stop operation and take the user back to the
screen of Figure IV-15. Pressing the ENTER/AUTORANGE key will cause the DV-II+Pro to accept
the new values.
Thatdone,theuserispresentedwiththefollowingscreen:
TIMED STOP
ENTER TO START
Figure IV-19
At this point the user must press the ENTER/AUTORANGE key to begin the timed stop operation. Any
other key press will be ignored except the
MOTOR ON/OFF/ESCAPE key which will cancel the process
and take the user back to the screen of Figure IV-15 where you will have to begin all over again.
We will assume that the user pressed the ENTER/AUTORANGEkey.Youwillnowbepresentedwith
thefollowingscreenforthedurationofthetimedrun:
Komentarze do niniejszej Instrukcji