Brookfield DV-II+ Programmable Viscometer Instrukcja Użytkownika Pobierz pdf (Strona 23)

Brookfield Engineering Labs., Inc. Page 23 Manual No. M/97-164-F1 102

L°F(FAHRENHEIT)

CGS UNITS

Figure 28

A press of the OPTIONS/TAB key at this point allows the user to “toggle” between the two available

data display units as shown in Figure 29:

L°F(FAHRENHEIT)

CGS UNITS

L°F(FAHRENHEIT)

SI UNITS

Figure 29

Pressing the ENTER/AUTORANGE key selects the display units, which are flashing, followed by an

exit of the Setup menu. You must press the ENTER/AUTORANGE key to select the flashing option.

III.2.3 Motor Speed Set Selection

This selection must be done with the motor off. Scrolling in the Setup options menu to the speed set

selection option yields the following screen display:

LCGS UNITS

SEQUENTIAL

Figure 30

The last selected speed set option is displayed, in this case, Sequential. For each press of the

OPTIONS/TAB key, the display shows selectable options (Figure 31). You must press the ENTER/

AUTORANGE key to select the flashing option.

LCGS UNITS

INTERLEAVE

LCGS UNITS

CUSTOM SPEEDS

LCGS UNITS

SEQUENTIAL

Figure 31

The speeds available in each of the above options are listed in Appendix F. The DV-II+ is initially

set up with the Sequential Speed Set at Brookfield prior to shipment.

III.2.3.1 LV/RV Speeds

In the case of Sequential or Interleave, a press of the ENTER/AUTORANGE key immediately selects

that option and exits the SETUP option menu.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 74 75

Brak uwag

Brookfield DV-II+ Programmable Viscometer Instrukcja Użytkownika Strona 23