Brookfield DV-III Ultra Rheometer Instrukcja Użytkownika Pobierz pdf (Strona 29)

Brookeld Engineering Laboratories, Inc. Page 29 Manual No. M/98-211-B0104

Brookeld Engineering Laboratories, Inc. Page 29 Manual No. M98-211-E0912

Note: If you are using an accessory device such as a Small Sample Adapter,

the complete kit must be congured for the EZ-Lock Unit to ensure

proper alignment and spindle immersion. Contact Brookeld for more

information.

Figures III-1a and III-1b shows the method for both connection systems.

Figure III-1a: EZ-Lock Figure III-1b: Standard Spindle

Standard Threaded Shaft

The spindles are attached to the viscometer by screwing them onto the lower shaft. Note that the

spindles have a left-handed thread. The lower shaft should be secured and slightly lifted with one

hand while screwing the spindle to the left. The face of the spindle nut and the matching surface

on the lower shaft should be smooth and clean to prevent eccentric rotation of the spindle. Spindles

can be identied by the number on the side of the spindle coupling nut.

EZ-Lock

Hold the spindle with one hand while gently raising the spring-loaded outer sleeve to its highest

position with the other hand. Insert the EZ-Lock Spindle Coupling so that the bottom of the coupling

is ush with the bottom of the sleeve, and lower the sleeve. The sleeve should easily slide back

down to hold the spindle/coupling assembly in place for use. [Spindles can be identied by entry

code; look for the number on the side of the EZ-Lock spindle coupling.]

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 132 133

Brak uwag

Brookfield DV-III Ultra Rheometer Instrukcja Użytkownika Strona 29